Most important upgrade for your Harbor Freight pot blaster! The Deadman valve review and demo!

13 Comments

1. Do they make a pistol version?

   Reply

2. Just bought one but it stays clogged up. Running 30/60 green diamond in it. Runs for about 10 sec and clogged up again.

   Reply

3. What are u using for media. Mine clogs and I have a dead mans valve and I’m using the fine tractor supply

   Reply

4. These little blast pots are amazing I just bought one and was surprised what it can do! I think the only real limitation to them is what size compressor you have. I also have a car project and getting into the corners in tight areas is an almost impossible job without this so it’s saved a lot of time.

   Reply

5. How much pressure are you using? I just bought one and running 60 gallon compressor and I’m only getting air out, no media, as if the valve at the bottom is clogged up

   Reply

6. Can you advise what blast media you are using ?

   Reply

7. what size air compressor would you recommend for this. great video.

   Reply

8. what are you using for an air compressor? PSI, Gallons, and cfm ?

   Reply

9. Do you know the part number on that?

   Reply

10. So what's different between the one that cam with it and the replacement ?

    Reply

11. Good info!!

    Reply

12. Unfortunately we don't have a Harbor Freight in Australia, but good info anyway.
    I have to say though, your "peace and grease sucker" at the end of your vids is starting to sound a little unenthusiastic. Not a complaint by any means, just an observation on something that sets you apart from your contemporaries lol.
    You still have the best intro and music just so you know. Cheers mate, love your work.

    Reply

13. I like my blaster a lot but you are right used it twice and the dead man leaks , so the new dead man that you bought stops that issue ?

    Reply