How To Make CBD Oil From Isolate



In this video I explain the steps to make your own DIY Sublingual Oil from CBD Isolate. For more information about CBD, from unbiased user reviews to …

42 Comments

  1. what is the most cbd isolate i can put in a 10ml of pg/vg and what ratio would the pg/vg have to be

    do you think its possible to create a juice that has 4000mg per 10ml without the juice crystalizing down the line

  2. Thank you for your reply. 2 more questions. 1 what would be a low, medium, hight, and max amount for cbd subliminal and vaping? Which would be better vape or subliminal? I know not to go too high just wanted to know starting point. The bottle15 ml is correct but didn’t account for the dropper

  3. I am new to cbd. I don’t want any THC due to testing and it makes me sick. Is all isolates 1000 mg per gram? And what does it mean 1000 mg on a 60 ml bottle from a shop? Also it said 99% what is the other 1%? May sounds dumb I am new. I have many chronic pain issues thank for any help

  4. You can also simply replace the oil with your vape juice, help it dissolve by putting the bottle in a hot water bath, shake it loads and vape to your hearts content. But I've noticed I get little effect from it. I know it's bad but I put like 160mg in a cigarette and omg the relief from anxiety is palpable. Hope that helps.

  5. Regular hemp CBD oil doesn't contain this much coconut oil. It's like basically vaping coconut oil majorly. And what if i want to purchase first cold pressed oil that has a hard form?

  6. If you want to mix it up squeeze up some into the air filters dropper few times as well as when closing it pinch the air in dropper so it done in some of the fluid this will prevent overflow and also mix up your solution

  7. I'm having trouble I'm doing 250ml 70vg/30pg mix with 8g CBD.
    I hot water bath it, it dissolves but then after a hour crystallise turns the juice to slush can any one help with what I'm doing wrong?

  8. I have a question if you dont mind. If you wanted to make CBD gummies using CBD isolate, do you still need to use a carrier oil, or can you simply mix it with the gelatin or agar agar? Thanks for the vid!

  9. Advice from a chemist:
    • Mix in a bigger vessel and then transfer that mix to your dropper bottle.
    • When the dropper displaces the liquid in the vial, try inserting the dropper having already squeezed the bulb and slowly draw up some of the liquid in the vial as you insert it and you won’t have quite so much air displacing your liquid volume. That is why you can’t fit 15mL in there PLUS the dropper full of air.
    • When weighing out your powder, you can place your mixing container on the scale, then tare it, then add your powder. This will minimize loss of product during transfer from weigh boat to mix.
    • if you are going to transfer powder from one container to such a small opening as you did here, use wax paper or parchment to create a funnel and you won’t lose more product spilling and resting on the lip.
    • I can pretty much guarantee the syringe you’re using is dead on accurate unless you went incredibly cheap on that, but if you’d prefer, you can use the scale to measure that as well. Just remember the density of your coconut oil is 0.92, so 15mL will weigh 13.8g.

  10. Good vid I make it the same way for my daughter she’s disability and it works. Have you tried full spec CBD so good I make mine in the shot glass using small pot little water I put a dab Matt in the bottom of the pot put the shot glass on top yes slow and low low low for 30min to bind everything then pour in to bottle thanks for make the vid nice simple and to the point 😘

Leave a Reply

Your email address will not be published.


*